Nintendo Switch is a portable gaming device allowing you to play your games on the go. The Nintendo Switch is plug and play on any Arcooda Game Wizard machine. Due to the original purpose of the Nintendo Switch being a plug and play/portable console, connection to the Game Wizard has never been easier!

Utilising the Game Wizard’s expansive capabilities, plug and play your Nintendo Switch to experience your favourite games in an arcade machine environment.


Instructions to Connect your Nintendo Switch into Any Game Wizard Arcade Machine

Step 1.
Inside your machine, check that your joystick control panel wiring is setup for console/PC play, and not set for Arcade/Jamma game play. (please check your manual for location).

Step 2.
After installing your Nintendo Switch inside the machine, plug in the Machine HDMI cable into your Nintendo Switch.

Step 3.
Plug in the Highway I/O board USB twin ended cable into your Nintendo Switch.

Step 4.
Change the front multimedia control panel set to Console. Depending on your machine configuration, the location of this switch will vary.


SUMMARY:


  • Game Wizard Panel Switch = Console
  • Hand Controllers Must Be Connected = Yes


  • Warning: Wireless Nintendo Switch hand controllers need to be connected to your arcade machine via USB cable. However, cable quality will influence performance (and may not register If the cable is low standard).



    Special Notes: Nintendo button layout is different to general XBOX/Playstation layout. If you are using only Nintendo Switch in your Game Wizard machine, please install the Nintendo firmware for the Highway I/O board which will change the button layout configuration on your machine. If you then would like to go back to XBOX/Playstation layout, please reinstall the regular firmware.

    Setup Instruction

    Nintendo Switch HDMI Connection to Arcooda Machine.jpg
    Nintendo Switch USB-Connection to Arcooda Machine.jpg
    Menu